La description
Basic features:     1, the simulator
built-in high-capacity lithium battery, can work long hours; fully
charged can work more than *0 hours (the factory). Because it is a
lithium battery, please try not to over discharge. Please note that
the proper use of the charger, the charger voltage can not be
higher than 4.2V.     2, using *0 universal
adapter for ECG, ECG machine and can be used with a variety of
monitors of lead wires to connect.     3,
the charger green light indicates charging is completed, the more
red light indicates that power is low.
    4, increase the low battery auto
shutdown features to protect the lithium battery. Instructions for
use: The simulator can produce the following waveforms, the first
waveform as a code representing 1, the normal ECG waveform 2,
positive and negative triangular waveform Note Note: 1, the
simulator automatically generated after power waveform a normal ECG
waveform. 2, the simulator LED display tubes, when there is no
operation within five seconds, it will automatically turn
off the display to save power. Press any to display the
trigger again.      Key Description:
            A
total of four s, followed by selection keys to increase the
key, down key, the Enter key, in addition to a set of key
combinations
           Select
:
           This
is used to select the parameter to be changed, a total of
four LED tubes to display the four codes represent the content
displayed from left to right,
           The
first representative waveform code, the first **4 represents a
parameter to change (the first two are numerical one hundred, the
first three on behalf of ten, on behalf of the first four bits)
           Each
one digital tube right lower leg with red highlights, representing
the current position is selected, you can increase and decrease
s to change it. Increase key: When using the Select to
select a good to change the content, use this key parameter
changes. Decrease key: When using the Select to select a
good to change the content, use this key parameter changes. Enter
key: When the parameter change is completed, this will confirm
to confirm changes to the parameters and generate the
corresponding waveform. Key combinations: Press the Select key, and
then press the Enter key, release the Enter key, release the Select
key, then select a key combination represents, press the Enter key
will display different content. Instructions say to use the various
waveforms, respectively, the method of operation:
    A normal ECG waveform: ★ heart rate
setting range :*****0bpm; (initial value: *0 bpm) ★ signal
amplitude fixed.     2, positive and
negative triangular waveforms: ★ Frequency range :*****0bpm;
(initial value: *5 bpm) ★ amplitude range :0.**4Mv (*0:0.1 mV,
**0:4 mV); ★ 2 modes, Mode 1: positive waveform Mode 2: Negative
waveform; through a combination of keys.
    8, the signal amplitude settings: ★
amplitude range: 0.1mV*4mV (*0:0.1 mV, **0:4 mV); (initial value:
**0) ★ Please note that this amplitude settings will affect all
waveforms. ★ Please note that the signal amplitude settings can
affect the ECG waveform amplitude.
| Pays: |
China |
| N ° de modèle: |
SKX-2000C
|
| Prix FOB: |
88 / Unit (Negotiable)
Obtenir le dernier prix
|
| Localité: |
Xuzhou, Jiangsu, China |
| Prix de commande minimale: |
88 per Unit |
| Commande minimale: |
1 Unit |
| Packaging Detail: |
Bubble wrap drop resistance |
| Heure de livraison: |
1-2 days can be shipped |
| Capacité de Fournir: |
987 Unit per Week |
| Payment Type: |
Western Union |
| Groupe de produits : |
ECG monitoring equipment category
|
