Shingle Tan is a kind of one-component polymer water soluble
urethane of the eco-friendly product and shows excellent
adhesion and forming the
elastic coating film provided with elegant color, flexibility and
firming strongly after drying. Shingle Tan has
a excellent weather
resistance, water resistance and breathability so that it is
suitable for waterproofing shingle sites where elasticity
is required.
â— Inorganic top coat
Construction Method
â— In order to maximize the performance of product enforce
the surface treatment before the construction as follows
â— Shingle joints or lifting parts must be repaired with
sealing products
Surface
Treatment
①Coated floor must be sufficiently cured (*0 ℃
standards, curing more than *0 days)
â‘¡ Ground laitance, dust, oil and other contaminants are
completely removed (pH7 ~ 9, the water content *0%)
â‘¢ Fill up the gaps or hole with repair putty. Seal the
severe cracks and expansion joints after V-cutting and coat surface
after adjustment
â‘£ Corner facing the wall and the bottom part and lifting
part of the maintenance work.
⑤ Other parts of the construction side, using masking tape
to protect
Construction / primer
work
â‘ After treatment based primer and brush, roller or
spray applied once
â‘¡ Enough paint to be absorbed when applied to the substrate
surface
â‘¢ The coating should be applied uniformly to prevent not to
be thicker coating partially.
â‘£ Primer paint for more than 2 days or rainy day with
moderate to enhance the adhesion between layers of primer and then
a thin
Sand Parpineg (0.2kg / ㎡) for additional application
Construction / moderate
work
â‘ Use a brush, a roller after confirming the complete
drying of the primer hard and apply in one direction
â‘¡ First do not thicken the coating during construction, and
3 times that split shingle work, can maximize the effect of the
shingle tan
â‘¢ Check the status of the application surface with a dry
place, ensure that there are noproblems occur, the
pinhole, then carried out the second application. Applied to the
primary and secondary coating work in the direction of
displacement
Construction and
maintenance
â— Refer to the complete drying time to control the pass and
walk to protect the coated surface.
â— Ventilate the indoor well when working with dry
â— To immature work due to fault area is cut suitable area to
be repaired and conduct construction method above
Notes
â— Please be sure to use undiluted.
◠Be sure to keep the temperature more than 5 ℃.
â— If adhere to your skin, wash thoroughly with soap and
water
â— Please keep out of reach of children
