1ã€ï¿½Apply the compound into any gap between the boards and fill
the taper.Cut a piece of tape and press into the joint.cover the
tape with the compound,and remove the redundtant,make sure the
joint keep the same level with the surface,the first joint’s width
is ******0mm.
2ã€ï¿½After the first coat is set and and dried apply a further
coat,extending *0mm to *0mm on each side.Ensure that the coat is
tight and featured into the board surface.
3ã€ï¿½Once the second coat is set and dried apply a final coat
extending *0mm to *0mm on each side ,ensure that it is tight and
featured into the board surface.
4ã€ï¿½After the final coat is set and dried ,the joint should be
lightly sanded using **0 grit paper held in hand or pole
sander.
APPLICATION:
The
compound should not be used in temperatures above *5℃ or below
0℃.It must be applied over every wallboard joint.To ensure an
adequate adhesion of the compound the tape must be firmly pressed
against the board using a hammer head joint knife,uniformly
distributing the compound.Likewise,apply multi-used compound over
screw heads and plastic or metallic corners.To obtain better
results,apply two or three compound layer over the tape.Clean
excess compound off the board before it dries.Make sure that dry
compound does not come into contact with the remaining mixture.
PRODUCT DETAILS:
Packing:In SH-F Bag
Weight:5kg/bag
State:
Powder
Stocking:Store off the ground and in a dry environment,for the one
haven’t used off seal to store.
WARNINGS
When
mixed with water,this material hardens and becomes very hot
sometimes quickly.Do not attempt to make a cast enclosing any part
of the body using this material.Failure to follow these
instructions can cause severe burns that may require surgical
removal of affected tissue or amputation of limb.Dust can cause
eye,skin,nose,throat or respiratory irritation.Avoid eye contact
and inhalation of dust.Water eye protection.If eye contact occurs
flush thoroughly with water.If dusty,water a NIOSH/MSHA approved
respirator.Prolonged and repeated exposure to respirable
crystalline sillica can cause lung disease and/or lung cancer.Use
proper ventilation to reduce dust exposure.Do not ingest.If
ingested call physician.
