Description
Specifications
Epoxy AB glue
Transparent & odorless
Curing time; **8 minute, *0minute
Pass MSDS and SGS
Nature:
Made by Germany imported original chemicals, transparent fluid,
solidify quickly under room temperature, strong adhesion, resist
from water, oil, acid and alkali. Castable and stuffable, grindable
after solidification.
Solidification: ***0 minutes (room temperature)
Cutting strength: >=*0Mpa
Adhesion: *0Mpa
Direction:
1. If the surface is not rough enough, use sand paper or grinder to
make it rough before applying glue.
2. Use acetone or spirit to clean the surface if possible, don't
leave any dirt or powder on it. Use cleanser with water for
replacement if the condition not available.
3. This easy-packing is for glue gun specially. Install the plastic
tube of SuTeGu onto the glue gun first, then fix a mixing tube onto
the open end of the plastic tube and make sure to keep it tight,
let the mixed adhesive squeezed out from the mixing tube under the
pressure of the glue gun.
4. Apply the glue evenly, use adhesive tape to tight and fix the
objects for ****0 minutes after being glued.
Caution: Use knife to remove unnecessary glue left on the objects.
When being glued onto skin, clean it with spirit or soap.
Seal the glue tightly after used and put it in dark and cool
place.
Keep the children away from the glue
Nature:
Made by Germany imported original chemicals, transparent fluid,
solidify quickly under room temperature, strong adhesion, resist
from water, oil, acid and alkali. Castable and stuffable, grindable
after solidification.
Solidification: ***0 minutes (room temperature)
Cutting strength: >=*0Mpa
Tensile strength: ***0PSI
Adhesion: ****4Mpa
Direction:
1. If the surface is not rough enough, use sand paper or grinder to
make it rough before applying glue.
2. Use acetone or spirit to clean the surface if possible, don't
leave any dirt or powder on it. Use cleanser with water for
replacement if the condition not available.
3. This easy-packing is for glue gun specially. Install the plastic
tube of SuTeGu onto the glue gun first, then fix a mixing tube onto
the open end of the plastic tube and make sure to keep it tight,
let the mixed adhesive squeezed out from the mixing tube under the
pressure of the glue gun.
4. Apply the glue evenly, use adhesive tape to tight and fix the
objects for ****0 minutes after being glued.
