Sell MB-06 Base Lacquer Putty By Guangzhou Mebong Architectural Decoration Co., Ltd., China
Pas encore membre de TradeKey.com? Inscrivez-vous pour vous connecter avec 9 millions d'importateurs et exportateurs. Rejoignez-le maintenant c'est gratuit |
BOOK A CALL
Book Call On Your Favorite Time
Code
🗘

By Signing Up. I agree to TradeKey.com Terms of Use, Privacy Policy, IPR and receive emails related to our services

Contact Us
Sell MB-06 Base Lacquer Putty

Sell MB-06 Base Lacquer Putty

|

Minimum Order

Localité:

-

Prix de commande minimale:

-

Commande minimale:

-

Packaging Detail:

-

Delivery Time:

-

Supplying Ability:

-

Payment Type:

-

Contacter maintenant
Membre gratuit

Personne à contacter Mr. Joe

Longkouxi, Guangzhou, Guangdong

Contacter maintenant

Description

Features:
This product is a new high-strength coating bottom ash, mainly used for the leveling rough surface of cement mortar or concrete walls, providing a good base surface for the layer lacquer putty, to reducing the amount of surface lacquer putty and low down the project cost
1, strong cohesive force, can be well attached to the base surface
2, has a certain flexibility, can be a good buffer layer for different substrates of stretching stress
3, excellent aging resistance and good ability of anti-infiltration
4, environmental-friendly product, non-toxic, and safety
Surface Treatment:
The substrate surface should be firm, dry and clean, no grease, no wax, and other loose materials. New plaster surface should maintenance about twelve days before inserting the lacquer putty, do not use cement paste for calendaring. If the wall is too dry, wet the wall before operation till there is no obvious water on the surface
Operation Process:
1, using appropriate amount of water (about 3: 1) to transfer it into a paste (namely *5kg powder 7.5kg water)
2, according to the water-cement ratio, pouring the water into the stirring barrel, adding the powder, using an electric mixer to make particle paste, put it aside for a few minutes and then a little stirring to gain the better effect
3, using point-mending method to repair the base side for those large different places, after dry use a spatula evenly to spread the slurry on the base surface, and control the thickness under 2mm.
4, dry after *4h, can make the operation of the surface lacquer putty.
Technical Reference:
Compression and shear bond strength

Send a direct inquiry to this supplier

To:

Mr. Joe < Guangzhou Mebong Architectural Decoration Co., Ltd. >

Je veux savoir: