Description
Servo driver product introduction
1〠Features of servo
driver
1. Quick response
Adapt to changing load conditions immediately
High performance fast function ring
Real time performance feedback
3. Safe and reliable
Reduce noise and additional hardware requirements
Over voltage, current and temperature monitoring provides higher
reliability
2ã€application
scenarios
Wide application, stable quality and large shipment。
3ã€Parameter table
The above parameters are for reference only. Our product technology
is constantly updated and upgraded. At the same time, we also
accept the customization and development of customers.
4ã€Product details
5〠Factory and
qualification
6ã€Instructions and
precautions
(precautions)
1. Electric shock hazard, the equipment must be connected to the
power supply under the condition of protective grounding
2. Avoid the risk of short circuit by placing the driver in a damp
place.
3. Do not use in dusty places.
4. Wear electrostatic bracelet to prevent electrostatic
breakdown.
5. Crystal products may be damaged under certain conditions. For
example, falling off the table or being impacted during the
mounting process. If the product has been impacted, it is not
recommended to continue to use it.
6. Exposure to radiation environment will cause damage to product
performance.
7. Do not use or store these products in an environment where the
pH range may cause corrosion or dissolution of products or
packaging materials.
8. Do not use the product in halogen gas environment. Even a small
amount of halogen gas, such as chlorine in the air or metal
parts
used for packaging, can cause corrosion. At the same time, do not
use any resin that will release halogen gas.
9. Store in indoor environment with temperature not more than 35
℃, relative humidity not more than 75%, and no corrosive gas
(instructions for regular maintenance)
1. Clean the dust on the servo drive every quarter with a special
cleaning solution. After cleaning the dust on the servo drive, dry
the circuit board with a blower.
2. Every quarter, observe whether the electronic components in the
circuit have the traces of high temperature, and whether the
electrolytic capacitor has the phenomenon of bulge and leakage, if
any, replace it.
3. Check whether there is crack or loose welding between pad and
element foot of servo driver printed circuit every quarter, and
repair welding if any
4. Retighten the interface screw of servo driver or replace the
screw every quarter.
5. Check the capacity of the electrolytic capacitor in the servo
driver every year. If it is found that the capacity of the
electrolytic capacitor is less than 20% of the nominal capacity,
it
should be replaced. Generally, the life of the electrolytic
capacitor should be replaced after about ten years to ensure the
working performance of the servo driver.
7〠After sales
service
1. Our company can provide installation, debugging and technical
training for all our products.
2. After the installation and commissioning, the warranty period is
one year (except for vulnerable parts and artificial damage), with
a lifetime warranty.
3. Irregular on-site maintenance, on-site operation and technical
training.
4. After sales contact: 0571-89167832.
5. Service content: in case of equipment failure, first communicate
by phone. If the problem cannot be solved, our company will rush to
the site as soon as possible to solve the problem. After sales
service includes not only equipment maintenance, but also technical
support. Our technicians can carry out on-site technical training
and provide a complete set of solutions. Professional and
technical
personnel shall follow up the use of user\'s equipment at any time.
