Description
1. Weight
unbroken plastic 4MM board 4.**5KG/m2
Ordinary plastic 4MM board **6.3KG/m2
2. Flexibility
One-way continuous plastic: strips with a width of *0 mm
transversely; strips with a longitudinal cut width of *0 mm; **0
folds back and forth. Aluminum splits One of the plastic cores
continues.
Ordinary plastic: Strips with a transverse cut width of *0 mm;
strips with a longitudinal cut width of *0 mm; **0 folds back and
forth. Aluminum splits Two plastic cores are broken.
3. Processing
Ordinary plastic: The main component is LDPE, high-pressure
low-density polyethylene. Can be slotted and bent, the general
aluminum-plastic panel installation is no problem, the building
with the not too high floor can use this plastic, there is no
problem, just the slot is bent into *0 degrees, no need to bend
into an arc, General plastic can be done, as shown below:
Unilateral continuous plastic: the main component is LDPE,
high-pressure low-density polyethylene. If the cylindrical shape
like this needs to be wrapped with aluminum-plastic plate, then it
should be made of plastic continuously. The radius of the arc is
more than **0mm. All plastics can be used. If it is less than
**0mm, especially less than **0mm and **0mm. The radius must be
constant plastic. Constant plastic performance is better, the
strength of the board, the adhesion of aluminum to plastic, the
surface effect of the aluminum-plastic board, will be better.
4. Board Surface
The aluminum-plastic composite panel made of one-way
continuous plastic is very small if the aluminum skin is very thin
0.*4mm*0.*8mm.
If the surface of the ordinary plastic is 0.*1MM, it will not
affect the defects of the door.
5. Characteristics
1) Excellent fireproof property
2) Super peeling strength
3) Perfect cold resistance performance
4) Excellent surface flatness and smoothness
5) Superior weather, corrosion, pollutant resistance
6) Even coating, various colors
7) Superior impact resistance
8) Lightweight and easy to process
9) Easy to maintain