Description
In general, if a bent pipe processing enterprise uses a high-end
pipe bender or a high-strength mold, companies often need to invest
relatively large capital to effectively complete it. If you only
use a curved pipe to lubricate the product, it is relatively fast
and low.
This can also meet the requirements of the company's product
quality to a certain extent.
In the traditional process, oil-based elbow lubrication can
effectively meet the needs of enterprises to a certain extent, but
oil-based elbow lubrication products are not easy to clean, so
environmental pollution is very prominent, so companies must take
more measures to eliminate them.
If the elbow uses its oil-based elbow lubrication products to
affect the quality of the final product, it will put more money and
energy into the enterprise, which can effectively meet the bending
quality requirements of the enterprise and can be avoided to some
extent.
And reduce the company's investment in oil-based elbow lubrication
products.
Each elbow product needs to be bent a few times during processing.
During use, the steel pipe can be placed directly on the bending
machine so that the bending machine directly bends the steel
pipe.
Torque can cause proper deformation of the steel pipe.
The effective amount of the processing elbow forms a certain angle,
so that the purpose of bending can be achieved to a certain extent,
the basic process is that the rear end clamp clamps the steel pipe,
and then effectively passes the front end lower mold
The main oil fulcrum of the movement.
In the process of processing, according to different manufacturing
methods, the elbow can be effectively divided into welding,
stamping and twisting. In the production process, the elbow can be
effectively divided into hot bending and cold bending.
The type, tube is related to the pressure received inside the
longitudinal tube during the tanning process.
The outer side of the elbow is subjected to the tensile force, and
the tube is elongated, and the wall of the tube is thinned so that
the center is unstressed and does not deform during use.
The surface changes from a circle to an ellipse.
When making elbows, it is necessary to pay attention to the minimum
bending radius of the pipe elbow. The product should be cold-bent,
and the aluminum-manganese alloy elbow should not be cold-bent.
Tubes of other materials can be cold bent.
Hot bending is no problem.
