Description
MGC1.7-6 Fixed Mine Car Introduction
MGC1.7-6 fixed mine car is mainly used for transport of coal and
waste rock, dragged by a locomotive or winch.Mechanical loading
demands the largest possible car consistent with haulage and
loading conditions so as to reduce the number of car changes and
time delay. When the mine car must be designed for the colliery,
shaft size may limit the mine car length and width. When a new mine
is opened, the fixed mine car size is often chosen arbitrarily,
subject to physical conditions as far as can be determined.
By the use of side and end boards, the miner can remove these
boards to shovel coal from the end or side without interference.
After which the boards are raised and a topping is placed on the
cars. In mines where the physical conditions do not limit the mine
car size, this is usually determined by the mine cars use.
Anthracite mines employing loading chutes from breasts use high,
large capacity mine cars.
The size of fixed mine car is determined by the physical conditions
of the mine. Low-coal seams demand low height cars. Poor roof
requiring timbering close to the track will often limit the width
of the mine car. The radius of the smallest curve will limit the
length of the mine car. In low-coal mines, large capacity is
obtained by increasing the length and width to counteract the low
height. Also by using special designs, which permit low mine car
bottoms.
MGC1.7-6 Fixed Mine Car Main Characteristics
1ã€High reliability
2ã€Long service time
3ã€Made by high quality steel
4ã€High Stress area welds eliminated
5ã€Mass and section thickness optimised
6ã€Simplified state of the art mainframe and easy to operate
MGC1.7-6 Fixed Mine Car Technical Parameters
Model
MGC1.7-6
Volume(m³)
1.1
Gauge(mm)
600mm
Wheel Base(mm)
550mm
Overall Size(LxWxH) 2000×880×1150mm
Traction(KN)
60
