Description
The Stay Away Mat is a touch sensitive training mat which says
“NO†when you can`t. It quickly conditions dogs, cats and
similar sized animals to avoid prohibited areas with a harmless,
low-power electronic pulse similar to static electricity. Safe yet
effective!
◆    Entering
a room
◆    Make
any area off-limits.
◆    Protect
your furniture.
◆    Indoor
training for dogs and cats.
◆    Jumping
on automobiles
◆    Protect
car paintwork.
◆    Make
rooms or other areas off-limits.
◆    Stop
cats jumping onto kitchen counter tops.
◆    Outdoor
stay away birds or other animals on automobiles or umbrella
◆    Two
power modes (Batteryalkaline or 6F*2 9volt supply; Adopter Input:
******0Volt, Output:9VDC **0mA****0mA, not include battery and
adpoter)
OPERATING GUIDE-
OVERVIEW
1.      Remove the Shock Mat
from its box. Lay it flat in a warm environment to allow it to
un-crease.
2.      Insert a new alkaline
type 9 volt battery or connect the adopter..
3.      Place the device at
its working location.
4.      Switch ON and the
power indicator light keeps lighting..
5.      Test the mat using
“Low staticâ€
6.      Wait for your pet to
learn about the mat.
INSERTING THEBATTERYor ADOPTER
On the front of the electronics controller, slide the battery door
open. Connect and insert a new 9Volt ALKALINE battery. Then slide
the battery door back into place. battery life is up to 4 weeks. We
recommend switching the Shock Mat OFF when not in use.
OR:
 Insert the *-Volt, **0mA****0mA
adapter into the controller, and connected to the power.(not
include)
Notice:
The batteries and adapters cannot be
used, remove the adapter when using the battery, when using the
adapter, please remove the battery
LowBatteryIndicator:
When
thebatteryis low, controller B voice every 5
seconds
LOCATING THE DEVICE
To operate properly the mat must be fully unfolded and not folded
back on itself. The surface on which it is placed should be
electrically non-conductive and dry. Do not leave objects on top of
the mat.
Switching the Stay AwayMatON:
To switch ON, momentarily press and release the pushbutton switch.
The lights will periodically flash to indicate it is switched
ON.
IMPORTANT: The Stay Away Mat needs to
calibrate itself to the surface on which it is placed. Calibration
occurs when you switch the controller from OFF to ON. Whenever you
change the mat`s location you must switch the controller OFF. Wait
*0 seconds. Switch the controller ON. DO NOT TOUCH OR MOVE the mat
for the next *0 seconds while calibration takes place.
Switching the Pet Mat OFF:
Press
ï¹ hold the
pushbutton switch for 3 seconds, then release. the LED will flash
three times with three times BB sound and long BB sound to confirm
you selected OFF.
Testing The Stay Away Mat
1.      Pressing the power
switch until the power indicator light keeps lighting.
2.      Touch the Stay Away
Mat with the side of your hand, rather than your sensitive
fingertips, to test its operation.
3.      Once the Stay Away Mat
senses your touch, its action BB sound, and sends static pulses to
the Stay Away Mat for 3 seconds, you will feel the pulses if you
leave your hand touching across 2 wires.
4.      If only the pet step
on the Stay Away Mat ,touch the wire with its legs, will cause the
static pulses.
TRAINING MODES
The Stay Away Mat offers three training modes:
◆    Low
Static Simulation.
◆    Middle
Static Stimulation.
◆    High
Static Stimulation..
Â
Three type: ***8, ***6, ***6inch
Â