Description
The controlled potential electrolysis principle is applied on the
H2S sensor. Three electrodes installed in the electrolytic cell,
which are working electrode, grounding electrode and comparison
electrode. A polarizing voltage is applied at the same time. The
electrolytic cell is isolated from outer part by a membrane. the
sample gas passes through it and reaches to working electrode,
produce an oxidation-reduction. A small current will output
from the sensor. This current is proportional to the H2S gas
Concentration
Infrared ray method is used to detect CO2 during logging in
WELLSTAR. Following are the detail operationm instructions;
* Measurement range: 0~**0%
* Sensitivity: ***0ppm
* Percision: 1% FS
* Repeat error: 2% FS
* Baseline drift: 1% FS/7d
* Noise: <***0ppm
* Data displayed in LCD
* Automatic scale and baseline adjust function
H2S Sensor
* Work voltage: **4VDC
* Measure Scope: 1~**0ppm
* Percision: 1 ppm
* Repeat error: 5% FS
* Responding time: Reach the *0% of maximum within *0 seconds
* Output singal: 4~*0mA (three wires)
* Life probe: *4 month
* Work temperature: **0°C ~ *0°C
Specifications
- range: 0~**0ppm
- responding time: <*0 second (*0%)
- Power Supply: **4VDC
- output signal: 4~*0 mA
- accuracy: 5%(full range)
- Temprature: **0~*0?
- Period of Validity: 2 Years
- Ex-Mark: DIICT6