FOB Price
Obtenir le dernier prix80 ~ 100 / Meter ( Negotiable )
|Minimum Order
Localité:
-
Prix de commande minimale:
Commande minimale:
1000 Meter
Packaging Detail:
-
Delivery Time:
30 days
Supplying Ability:
200000 Meter per Month
Payment Type:
T/T
Personne àcontacter Mr. Jame
481#,HuangHe Road, Dongying, Shandong
The Structural
Glass Balustrade System is our innovative aluminium channel system
that holds glass panels in place for use on balustrades and
partitions.
1.
The aluminium base rail should be put into place, and the holes
marked onto the substrate for drilling, the aluminium base rail
should then be levelled and plumbed up with the use of shims. Once
the shoe is plumb and level the fixings should be tightened up to
make the channel rigid the fixings should be tightened in
accordance with the manufacturers
2.
The glass slip clamp needs to be placed on the bottom of the glass.
This requires lifting the glass off the floor sufficiently to
squeeze these on or turning the glass upside down. The slip clamps
require spacing according to the glass thickness these are as
follows :-
· All glass types require 4 clamps per metre
so number one should be in **5mm from the end of the glass and then
**0mm there after.
3.
Once the glass is fitted in to place you now need to press the
clamp bars into the top of each glass slip clamp. These need to be
put in the right way for correct and proper fit- ment this is shown
in the image right.
4.
Once these are in you now need to place a spirit level on the glass
to get the glass plumb. These bolts now need tightening into the
channel equally to keep the same pressures on the glass. To achieve
this firstly plumb and level each end of the glass and tighten.
Then tighten the intermediate clamp bars.Once the bolts have
pinched they now require an additional quarter turn to lock the
glass in place.
5.
The gasket requires feeding into the smaller channels supplied.
Once these are flush with each end the strip now needs to be
clipped onto the top of the channel this can be done by press- ing
the whole thing on evenly or working from one end which is
recommended. Do not stretch the gasket.
6.
Once you are happy everything is in place and the job is complete
you need to clean the glass and channel we recommend the use of any
stan- dard glass cleaner so long as it is not abrasive. We also
recommend a soft sponge or cloth again to avoid any risk of
scratching
NOTE: We have tried to make the system as simple and easy to install as possible, however should you not feel confident enough to fit this please contact a reputable glazier or builder.
