Description
There are seven types helical bevel geared motors, Here we just
take the RX type as an example.
Unique features of our products
Highly standard mudular design: They can be combined with other
motors easily or can be started by other driven power. The same
product can be used together with motor with various input powers.
Therefore it is easy to adapt to different motors.
Ratio: It ranges widespreadly. Very big final ratios can be
obtained through combined unities to reach extremely low output
speed.
Mounting: You do not have to abide by strict regulation.
High strength compact dimention: High strenghed cast iron is used
in the housing; Gas carbusing process and precise grounding are
sandwiched between the gear and the shaft therefore it is possible
to bear high loading capacity.
Long life expansion: Our products survive other products of the
same standard due to our unique matiral, design and technology
Low Noise: All components are processed tested and assebled
accurately and technologically there little noise is produced
during their operation
High efficiency: Our products can work efficiently no matter under
what circumstance they are.
Large radial loading ability
Axial load ability of upto5% of radial load
Working environment
They can rotate on both directions
They are not limited to a specific industry
If there are any other problem feel free to contact our technology
department
Drawings and pictures are attached in this catalogue are regarded
with no strict accordance with products. The exact CAD drawing and
dimension of certain type can be offered if necessary.
To avoid accident, all rotative components must be installed with
dust hood to comply with national and regional safety
regulations.
Charge-free radial seals will be added on delivery, please specify
if there are other requirements.
Iron-cast surface is painted blue or gray.
Aluminum-die-cast surfac silver, other colors or special lacquer
should be specified if you are not satisfied with the above mention
colours.
Location of breather valve, oil drain plug, oil level plug and oil
dipstick is subjuct to our drawings of different types. Special
requirement should be spicified when you order our products.
All reducers can rotate on both directions( except installation of
backstop) in this catalog, but only one input directon is marked,
as the input direction changed to the opposite will cause change of
the output direction. The output directon has a close link to the
inner structure and input direction, to number of stages of helical
gears, to relative position of spiral gears, to the rotation
direction of worm in worm gear units.
Please read the catalog before running the reducer.
Gear units have been debugged, but lubrication should be added
before being run.
Shrink disk, involute spline, motor base, flange and backstop
connected with servo motor, cooling fan, lubrication cooling and
controller will be specified if necessary. We will offer
reference.
Please consult us for special products because all information in
this catalog is subject to general standards
