Description
Push-pull mold vulcanizing machineposed of frame plate, hot
platen, up and down platform, piston, oil cylinder, front and rear
sliding mold device, hydraulic station and electric control system
etc. The plate welding with Q**5 steel, through machinery shot
blasting, spraying zinc-rich lacquer, rapping into machining to
eliminate stress. Hot plate is of dual sizing rolls and processing
by *5# steel plates through normalization treatment; the steam
inlet of each hot plate is provided with a group of electric valves
which automatically adjust the temperature of the steam; to meet
the vulcanization process requirements, at the front of the intake
manifold plus the bypass valve. According to job requires manual
(or electric) to switch into the steam / feed water valve, and
hydrophobic / bypass valve. The up and down the platform is of Q**5
steel. In order to ensure the production precision using automatic
cutting stock, planer processing of welding groove, carbon dioxide
gas shielded arc and welding by alloy welding wire, and after that
as a whole into the furnace for heat treatment topletely eliminate
welding stress, then machining to ensure not deformed. Cylinder
using ZG******0, plunger is of chilled alloy cast iron, sealing
structure is double seals plus thebination of a dust ring structure
to ensure the long-term use. Front and rear sliding mold device
using hydraulic sliding or mechanical sliding two ways, can bear
any weight of the mold. Electric control system adopts PLC full
automatic control, can be achieving automatic clamping, open mould,
exhaust settings, and can also be converted to manual control. 3.
The vulcanizing press through a **-hour pressure test, pressure
maintaining to detect the cylinder plunger bearing capacity to
ensure that no oil spill, no oil leakage, avoid unnecessary
equipment quality troubles for customers. 4. We can design kinds of
non-standard vulcanizing press according to customers specific
requirements. Model XLB****0x***0 Total Pressure (MN) *6.*0 Platen
Size (mm) ***0x***0 Platen Distance (mm) **0 Working Layers 2
Piston Stroke (mm) **0 Hydraulic Cylinder Diameter(mm) **0
Hydraulic Cylinder Qty.(set) 4 Close Mould Speed (mm/s) *6 Open
Mould Speed (mm/s) *5 Motor Powder(Kw) *6
