FOB Price
Obtenir le dernier prix( Negotiable )
|Minimum Order
Localité:
shanghai
Prix de commande minimale:
-
Commande minimale:
1 Piece
Packaging Detail:
fumigation wooden packaging
Delivery Time:
7 days
Supplying Ability:
2000 Piece per Month
Payment Type:
PayPal, Money Gram, Western Union, D/P, D/A, L/C, T/T
Personne àcontacter Ms. Cherry
No.101 NanTing Road Baoshan district, Shanghai, Shanghai
I. Water-fill hoses tips:
Over time, the water hoses that
came with your new washing machine may leak or burst. It’s a good
preventive maintenance practice to check these hoses from time to
time for any sign of wear or weakness. Often there’s a small
blister in the rubber of the hose, which could rupture. Most
manufacturers recommend replacing the hoses every 5
years.
Please note that if the hose ruptures, large quantities of water
could gush from the hose. If it’s the hot water hose that ruptures,
the gushing hot water may scald anyone nearby.
For more peace of mind, one alternative is to use high quality
stainless steel fill hoses. You can find them in our parts section
under washer/dryer. In addition, we carry the black rubber hoses
supplied by the manufacturer, use our PartDetective to locate the
ones for your unit. And, universal washing machine hoses, also in
our parts section.
II.Leveling tips:
Because your washing machine is so heavy, when it’s not level, it can vibrate strongly during the spin cycle. If your washing machine is not perfectly level*-with all four legs touching the floor*-it can bang and rock back and forth, and even begin to "walk" across the room. This isn’t good for the machine and may damage anything near the machine.
Your washing machine has
adjustable, front leveling legs with a lock nut. You adjust the leg
to the proper height, then tighten the lock nut up against the body
of the machine to keep the leg from rotating. Some machines have
adjustable leveling legs in the rear also, and you can adjust them
in the same way. Keep the machine as close to the floor as
possible*-the lower it is, the less likely it is to vibrate.
Most machines, however, have "self-adjusting" rear legs. You set
these legs by tilting the entire machine forward onto its front
legs (with the rear legs 3 to 4 inches off the floor) and then
setting the machine back down.
The legs should adjust automatically. If they don’t, you may need to tilt the machine forward and rap on the rear legs with the handle of a hammer to loosen them*-a procedure that’s easier to accomplish with a helper.
III.Surface cleaning tips:
Your washer has either a painted
steel or carbon steel-coated steel cabinet. It’s perfectly safe to
use a little dish detergent and a damp rag to clean all of its
surfaces. If the surface is carbon steel, you can even use a little
non-abrasive cleanser for stubborn stains.
