|
Features of tile
1. Conductivity
·It satisfies the electric resistance of UL **9&NFPA
*9.
·Surface electric resistance:*04**06Ω
·Static decay time:5.**0lts to zero 0.*5sec.
2. Durability
·Excellect anti-wear,and anti-chemical properties.
3. Uniform gauge and color maintenance
4. Anti-load property
·There is no problem with machine movement,carrier vehicles or
beds.
5. Permanent conductivity
·Conductive materials is distributed evenly in entire so that it
has permanent conductivity.
6. Non-flammable
Conductive tile (installation method)
Proper supplementary materials shall be used for conductive tile
installations.The function of electric conduction may be
demonstrated only by exact methods of a skilled
contractor.
Sequence of installation
1.Arrangement and preparation of floor. Dry conditon without
contaminants.
2.Drawing of tile construction line on floor with chalk
line.
3.Drawing of construction line of copper tape.
4.Application of adhesive (drying time ****0 minutes after
application of electro conductive adhesibe).Use special adhesive
only!
5.Installation of copper tape
(1) Install so that it will be crossed at center of
tile.
(2) Leave allowance of about *2'' for copper tape at the place to
be grounded.
6.Installation of tile
(1) Select start point of tile construction after adhesive
dries.
(2) Install from center of chalk lines.
7.Welding of tile connection part
(1) Route V shape groove of about 1/2 times the thickness of tile
along tile seam after adhesive harden sufficiently to hold tile in
place..
(2) Perform welding with welding machine using PVC welding rod of
3.5 mm diameter.
(3) Level the projecting part of welded part with chisel knife so
that it may be level to tilesurface.
8. Grounding: Do grounding by connecting ground wire (copper tape)
to grounding point if installation of tile is complete.
Maintenance and control
1. Remove detergent component completely after cleaning using
neutral high quality detergent after removing dust for general
cleaning. Rinse at least twice,more if necessary,with clear fresh
pure water.
2 Clean contaminated parts carefully with mild
detergent.
3 Do not use wax. If necessary,use polisher.
Uses of tile
Manufacturing, assembling and inspection factory of semi-conductor
company
Clean room,computer room
Producting,assembling,laboratory,and test place of electronic
product
Operation room of hospital
Place to handle explosives and flammable gas
Access floor
Telecommunication corporation (electronic switching room,etc.)
(finishing material of conduction room)
Supplementary materials
1.Copper tape 0.**5T×*0mmw
2.Electro conductive adhesive: ******6.
3.3.5mm diameter for PVC welding
|
