FOB Price
Obtenir le dernier prix|
Minimum Order
Localité:
-
Prix de commande minimale:
-
Commande minimale:
-
Packaging Detail:
-
Delivery Time:
-
Supplying Ability:
-
Payment Type:
PayPal, Money Gram, Western Union, T/T
Personne àcontacter Mr. Jaden
Rm 1105, Unit A, Fuxing Garden,, Shenzhen, Guangdong
BMW EWS2, EWS3.2
EMULATOR
Support Type:E*4, E*6, E*8, E*9,
E*6.
INSTALLATION:
1. Remove original EWS2 control unit, find **2v ACC, GND,
K-line wires, attach emulator. Emulator
must be in service mode: JUMPER 1 shorted.
2. Connect ANY K-line diagnostic adapter to vehicle
diagnostic connector and launch EMULATOR
CONFIGURATION
UTILITY:
3. Choose COM port, write in desired ISN number, press
button Store. Or-
4. For some ECU\'s it is possible to read ISN number
directly from engine control unit. In this case
select option "ECU xxxxx", press Read. Software
will try to read ISN. If successful, choose option
"EWS emulator" and press button Store to save
ISN number into emulator.
5. Disconnect emulator from K-line, remove JUMPER 1 and
connect K output from emulator to
DME(DDE)<一>EWS line.
6. Don\'t forget to short two starter relay wires (EWS
connector)!
7. Car is ready to start.
In case of EWS3.2 similar procedure is used, only difference is
that that it is NOT connected directly to
diagnostic K-fine.
There are NO any counters or car starts limited. You can change and
store new ISN without any limitations.
Emulator is shipped with JUMPER 1 shorted. For testing purposes ISN
***9 is stored by default.
