Description
I:working conditions
1.Cylinder diameter : diameter
******0mm
2.Working piece
thickness :***0.6mm
3.Maximum tank length :L=***0mm
4.Pressure groove
depth≤ mm
5.Pressure tenon width≤ mm
6.Material :pearl plate, galvanized ,stainless
steel, titanium etc….
II:
technical parameter, requirement
1.The
rated voltage : **0VAC *0HZ
2.Rated power :0.5KVA
Bending and pressure , the
height and width, , According to customer requirements, if
no special requirements, according
II:conventional production requirements
1.compressed air pressure:
0.*5mMpa ~ 0.6mMpa
2. The Pneumatic components
:cylinder, solenoid valve ,is from AIRTAC
It is applicable for the
tenon-mounted water barrel to be solid-pressed and get a
nonrecurring forming,water tanks for solar water
heater vacuum
tube in two holes fold one side of
the ribs, the solar water heater vacuum
tube inside the barrel hole placed on
a flat surface, so
that vacuum holes **3 point increase
instrength, in the operation does not
cause pore deformation, reducing
scrap, sheetbend does not
produce pressure marks, no special mode With, the
use of low-cost, easy installation and
operation are with high flatness.
