Description
Features & Benefits of Ball Mills
1 . The ball mills are made up of feeding part,
discharging part, gyre part, transmission part (reducer, small
transmission gear, motor, and electrical controller) and so on.2 .
The ball mills' hollow axis adopts the cast steel, and the lining
can be replaced. The big rotary gear is forged from cast rolling
gears.
Working Principle of Ball Mills
This ball mills, a horizontal type and tubular running, has
two warehouses. It runs along the outside gear. Materials spirally
and evenly enter the first warehouse along the input hollow axis by
input devices. In the warehouse, there is a ladder scale board or
ripple scale board. Steel ballsof different specifications are
installed in the scale board. When the barrel bodyrotates,
centrifugal force is produced. At the same time, the steel balls
are carried to some height and then fall to grind and strike the
material. After being grinded coarsely in the first warehouse, the
material then enters into the second warehousefor regrinding. In
the end, the powder is discharges by output material board.
The Operation Rules of the Ball Mills
1.The operators must be qualified with the required technical
knowledge, receive technical training and fully understand the
operating principle, performance an regulations of the ball
mills.2.The operators should follow the operate principle and
lubricate the requirement parts marked in lubrication
picture.Untreated waste oil may not be used and keep lubrication
points clean.3.Pay attention to check the temperature of bearing
not to exceed *0 ℃ and make sure every bolt
not loose,no abnormal sound,uniform mining feed,steady water
feed,normal current,voltage of motor.4.To keep surroundings clean
where the ball mills run.Every party should be clean unless it's
running.
