Description
Accepted by technique requirements in JC/T*******1. Excellent
water resistant ability, strongly bonding to the substrate. Resist
to the slight shake of the construction and fill the micro cracks.
Widely used for waterproofing of where might have small shake and
micro-cracks, such as underground parking, tunnel, pipeline, wall,
roof, floor, internal angle and external angle.
PRODUCT FEATURES
â—†Excellent
waterproof performance, weather resistance and aging
resistance
â—†Can apply
on wet substrate, for waterproofing inside and outside
â—†Superior
adhesion, bonding the substrate tightly
â—†Good air
permeability, keep the substrate dry
â—†Environment
friendly, no smell and no toxic
APPLICATION
â—†Interior
and exterior concrete substrate, cement rendering, light brick
substrate
â—†Wall, floor
and roof of constructions, such as basement, tunnel, bridge,
kitchen, balcony, swimming pool and so on
â—†Construction
may occur small shake and crack, such as pipe around, interface of
late poured bands, inside angle and outside angle,
etc
SUBSTRATE PREPARATION
â—†Substrate
should be firm, stable and clean. Gap and holes needed plugging and
leveling
â—†Before
construction, wet the substrate and keep it moist, but make sure
without water on it
CONSTRUCTION TECHNOLOGY
â—†Powder :
liquid = 1 : 0.*8. First pour the liquid to stirring tub, stir the
liquid while pour the powder into the tub slowly. Fully stirring to
be paste with no powder and precipitate. Stir the paste again after
settling down for several minute and be better
â—†Brushing
the mortar directly on the substrate and brushing again and again
if bubble coming out to squeeze out the air
â—†After
brushing the first layer of mortar and be curing a little, start to
brushing the mortar the second time crossly
â—†Don’t stir
too much for one time. Dispose of the stirred mortar if get cured
in the tub
CAUTIONS
â—†After the
coating cured, use spraying water to maintain
â—†Places
especially damp and unventilated, like basement and sealed drinking
pool, should use ventilation to accelerate the waterproof coating
get cured
â—†Applying
the product between 5~*0℃. Not allow to apply the product
outdoor on rainy days
MIXING RATIO: powder : liquid = 1 : 0.*8
CONSUMPTION
â—†Thickness
1.0mm about 1.5kg/㎡
STORAGE
â—†Shelf life
*2 months in dry and cool place unopened
EXECUTIVE STANDARD: GB*********9