Sell Fixed step cutting machine

Description

【Introduction 】

(1). Cutting machine is one of the main equipment of the （AAC)production line. Compact structure, easy operation, seldom needs to repair.
(2)This cutting machine is one of the main equipment of the (AAC) production line.
(3) The annual output of the AAC production line is over ****0 cubic meters, cutting machine is necessary equipment which increases the efficiency and improve the product quality.
(4）Our JQF sense of cutting machine can cut the cake in one step by turning it over.
(5）Because of its advanced technology, we just need to swing the cake once.
(6）so we can reduce the damage to the cake. Due to its advantage, our cutting machine is well-received.
(7）After years of technical innovation, we have many different models of concrete cutting machine.
 
【Advantages】

1. Compact structure, easy operation. Seldom need being repaired.
2. Complete the horizontal cutting and vertical cutting at once time.
3. Cutting each side of the cake, its cutting precision can meet the requirements if GB/T*********7.
4. It can be used to produce panel, its cutting precision can meet the requirements of GB*********5.
5. Recycling all the scraps, no second pollution occurs.
6. The cakes won't adhere to each other.
7. Crosscut adopt screw transmission which solves the problem of desynchronize caused by hydraulic transmission.
8. Restrainer and safety interlock can prevent the accidents by improper operation.
9. We can replace the steel wire quickly, the steel wire is tense pneumatically and it can swing in two directions.
*0. No defective products.
 
【Working Principle】

Turning over sling turns the mould with *0 degree and demoulds it, the cake together with the side board of the mould are placed on the cutting cart. Started by the motor, the cutting cart moves slowly through the functioning vertical cutting device to complete the vertical cutting. Then it moves to the middle of cutting device and stops there, the cross cutting device is started at this moment. The cutting frame drops vertically, then after cutting the cake horizontally. Cut the cakes from the horizontal side it will return to its original position.