Description
The benefits of this
test method are:
Conductance correlates directly to the battery capacity
Passive testing method is safe.
Never discharges or drain the battery.
Able to test condition of discharged battery.
Consistent and repeatable results.
Provides unique indication of battery conditions.
Besides, this analyzer also provides check the Alternator's
charging and Starter's cranking conditions.
It is maintenance free and no internal batteries required. It
powers up when connected to the battery posts during testing.
Key
Features
Simple and easy to use
Test batteries on and off the vehicle
Accurate results in milliseconds
Battery Life Analysis
Analysis Result : Good or Replace
Large easy to read LCD display.
Test results based on JIS, EN, DIN, SAE and IEC
Standards.
Check Alternator charging conditions
Check Engine Starter conditions.
Functionality:
Test Result: Good or Replace
Capacity - Cold Cranking Amps (CCA), DIN, EN and IEC
information relative to battery rating.
Internal resistance value (m&branded; )
Life in percentage (%)
Application:
Use to test a wide range of *2V batteries (Starting [SLI],
Deep Cycled and Marine) of Wet (Flooded), VRLA or Maintenance Free
(MF), Sealed Maintenance Free (SMF), Absorption Glass Mat (AGM) and
GEL cell. The major battery standards JIS, SAE, EN, DIN and IEC are
supported.
Operating
Parameters:
System voltage: *2 Volts
Input voltage range: 9V~*5V
Power requirements: No internal batteries required. Power on
when hooked up during testing.
Testing range: **0 ~ ***0 CCA, **0 ~ ***0 DIN, **0 ~ ***0 IEC,
**0 ~ ***0 EN
Test Time: Less than 5 seconds.
