Description
DL-DT Elevator Trainer
I. Overview
This trainer supply various function detecting singles of modern
elevator control equipment, control actuator and display
components. Detecting signal can be divided into External Call
signal , inner select single, flat bed signal, position detect
signal, car gate open and close position signal, etc. It can be
divided into up and down function, car gate have the function of
switch, and position protection. Display every floor and current
car gate position display, function direction display, external
call, inner selection, line direction display external call and
selected signal and response. All the interface in the set use 4mm
safety sockets to connect to the control panel. There are 3 control
method (PLC control, MCU control, PC control), it can fulfill all
the system control function.
Auto function use MCU control, direct start elevator control
external panel and elevator control external button display panel
to control elevator function.
When there is PLC control input and output interface to up machine
communication interface, it can connect PLC to control the elevator
function.
You can use turn switch to SA1, you can change the control method
as MCU control /PLC control /PC control.
There is up machine monitor, can directly monitor elevator
function.
II. Technical parameter
1.AC power :single phase AC**0V±*0% *0Hz; with protect three-core
sockets（ISO standard）
2. Temperature: **0℃～*0℃; environment humidity:
≤*0%（*5℃）；
3.Whole capacity: ≤**0VA
4.Dimension: **0×**0×**0（mm）
III. Safety
Transparent mechanical protection measures, avoid directly connect,
elevator up protection and down protection, valid protection.
