Description
universal lambo door for any car use
Advantages:
·
Four heavy duty Gas Struts
·
Truly *0 Degrees of Door Movement
·
Adjustable Stop Points
·
**0% CNC/CAM machined Nickel-plate steel
construction
·
CAD Designed
·
Smooth Operation
·
Maintains factory safety, accessories &
function
·
2 Upright Door Hinges (Left and Right)
·
They are universal and can be fitted to any
vehicle
·
Detailed Instructions
Features:
-
Truly *0 Degrees of Door Movement
-
CAD Designed
-
Smooth Operation
-
Adjustable Stop Points
-
**0% CNC/CAM machined Nickel-plate steel construction
-
Maintains factory safety, accessories & function
-
2 Upright Door Hinges (Left and Right)
-
4 Heavy duty Gas Struts
-
They are universal and can be fitted to any vehicle
-
Detailed Instructions
-
Net weight: *0kgs
3.
Installation:
WARNING: This is a universal
kit, and may require custom modifications. We highly recommends
professional installation by a custom fabrication shop.
Installation
steps:
1. Disconnect battery.
2. Remove door panels and lower dash panels for easier access.
3. Remove fenders, and all necessary parts to remove them.
4. Remove door stop bar if applicable.
5. Remove all wiring running in to the door.
6. Close door and remove upper hinge.
7. Test fit Protocol Upright Door Hinge for correct placement on
vehicle.
8. Be sure that the location the hinge will mount is flat, remove
any unneccassary flanges or mounts.
NOTE: if cutting must be done be sure the chassis structure remains
in fact.
9. Hold the hinge in place and tack weld it in position, on chassis
and door.
*0. Be sure all measurements are correct before welding, or you may
need to cut the welds and start over.
*1. Remove lower hinge.
*2. Open door and test the swinging motion.
NOTE: use caution as there is nothing holding the door up.
*3. Close door and replace fender to test the fit and motion.
*4. Open door slowly, mark locations on fender that will need to be
rolled or cut away, fender flange may need to be removed for more
clearance.
*5. Mark location on safety limit bar (on upright Door hinge) for
correct outward movement.
*6. Extend all wiring running
into the door, to allow for vertical travel, (solder all
connections to prevent electrical problems) open and raise to
measure for wire length. Remove wires from the loom and cut. Cut on
wire at a time to prevent mistakes. Solder the appropriate
extension lead and tape/heatshrink. Repeat with all wires. A longer
wire loom may be needed.
*7. Make all the proper adjustments, to allow for smooth opening
and closing operation. See Fine Tuning section below.
*8. With door open, attach strut to the hinge, locate and mark
mounting position for ball stud on chassis.
*9. Attach ball stud to chassis using either the supplied mount or
fabricate one for your specific application.
*0. Re-attach fender and all parts, that were removed and test
motion.
