FOB Price
Obtenir le dernier prix|
Minimum Order
Localité:
-
Prix de commande minimale:
-
Commande minimale:
-
Packaging Detail:
-
Delivery Time:
-
Supplying Ability:
-
Payment Type:
-
Personne àcontacter Mr. Alan
Buji Town, Shenzhen, Guangdong
Cooling water plates for thermoelectric modules Dimensions: *0**0*9.5mm;*0**0*9.5mm; *0**0*9.5mm for cooling thermoelectric modules Custom design Plastic Gear Pumps Type: PG3/DC*2A Lift max: 1.5m Flow Max: 1.3L/min Input Power: 8W Input Voltage: DC*2V Suction Lift: **0mm Continuous Working Period: ï&frac*4;Å“5 min Type: PG3/DC*2B Lift max: 1.5m Flow Max: 1.9L/min Input Power: 8W Input Voltage: DC*2V Suction Lift: **0mm Continuous Working Period: ï&frac*4;Å“5 min Brief Introduction: The user manual is applicable for the installation and usage of various types of full plastic micro-gear pumps produced by our company. Operation method: output with pressurized fluid When it is put into service for the first time, please connect the wires according to the voltage parameters on the nameplate, red wire to the positive pole, black (or yellow) to negative pole. It is adivsed to install the micro-pump vertically downwards (pump under the motor) or lay it horizontally and fix it. Do pay attention to the directions of inlet and outlet when connecting pipes for the first time(bigger pipe orifice is inlet, smaller is outlet). Please check if there is any leakage of water or air at the inlet and outlet after installation completed, otherwise, it may affect the work of pump. Do not let it race over *0s (without water) when it is put into service for the first time. The diameters of the particles contained in the media suctioned by the pump shall be less than *0um. Fluid applied and fluid temperature: liquid viscosity: ******0 CPs (***** water, oil, honey etc.), temperature: 0℃***0℃ Ambient temperature and humidity: 0℃**0℃ï&frac*4;Å’*0%**5% The output flow of this micro-pump can be changed by adjusting input voltage to change the flow of pump.
