1KW GRID TIE POWER INVERTER

Description

1. Descriptionï&frac*4;š  Directly connected to solar panel designï&frac*4;ˆWithout batteryï&frac*4;‰  Angle with high precision auto-detect if it was held 0 Total  Step directly modulated high-frequency phase  Pure sine wave output  Solar luminosity power automatically adapt  Automatic power locking  Maximum Power Point Tracking(MPPT)  Automatically adapt to different load power factor  Constant current, constant-power design  Power grid automatically shut down when the output is faulty  Current limit protection  Schmitt trigger SPWM Generator(Output Pure sine wave)  Straight-line with the design  Multiple stack(Use of multiple machines in parallel)  Design of high frequency and high conversion rate 2. User Guide: Installation & Connection 1.1 Red Terminal: to connect positive pole of DC; Black Terminal: to connect negative pole of DC. AC Socket: to connect grid. Switch: Power Switch, after the proper connecting, turn on, Inverter start working. DC Input limits: Operating Voltage range: *2.5V to *8V Maximum input Voltage: *8V Solar Panel: *0W minimum, only use PV panels with maximum power voltage at *7.5V. Can ONLY connect panels in parallel. DO NOT connect them in series! Wind Turbine: Rated output voltage *4VDC, Maximum voltage *8VDC AC Output: Grid Connection: **0V AC version: **0V***0V, *0Hz **0V AC version: *0V***0V, *0Hz Island Protection: Automatically disconnect when the grid is tripped Maximum quantity of Pure Sine-wave Inverters allowed on a main circuit: No limited LED Indicators: Red LED on: Input DC voltage is too high or low (less than *2.5V or more than *8V) Red LED on: Over Heat protection once over *0℃, automatic restart after cooling down for about ***0 minutes. Red LED on: Grid blackout fault Green LED Flashing: Output power in the state of regulation. Green LED on continuously: Inverter works normally, constantly max. output power. Caution: Please do install the inverter in a ventilated area to avoid over-heating Clear out any flammable object around the installation Recommend a maximum output DC input cable size of 4AWG or cables that can handle more than *0A. Optimal length would be 8m or lower, Longer cables will experience higher voltage drop. Install in a low humidity and well-ventilated area. Remove All flammable objects. Connect the inverter to a wall socket with the supplied AC Power Cord Connect the Solar Panel, Battery or Wind Turbine&#**9;s DC Supply cables to the DC input Terminal of the inverter. Wind Turbine installations will require respective charge Controllers and dump loads