Sell 4E1 to Ethernet Converter By shanghai Baudcom Communication Device Co., ltd, China
Pas encore membre de TradeKey.com? Inscrivez-vous pour vous connecter avec 9 millions d'importateurs et exportateurs.
Rejoignez-le maintenant c'est gratuit |
BOOK A CALL
Book Call On Your Favorite Time

By Signing Up. I agree to TradeKey.com Terms of Use, Privacy Policy, IPR and receive emails related to our services

Contact Us
Sell 4E1 to Ethernet Converter

Sell 4E1 to Ethernet Converter

|

Minimum Order

Localité:

-

Prix de commande minimale:

-

Commande minimale:

-

Packaging Detail:

-

Delivery Time:

-

Supplying Ability:

-

Payment Type:

-

Contacter maintenant
Membre gratuit

Personne à contacter Mr. robert

Meijiabang RD1505, Shanghai, Shanghai

Contacter maintenant

Description

4 port E1 to Ethernet converter, E1 port support *5ohm or **0ohm, Ethernet port support *0/**0M bps. LAN-WAN connectivity Realize transparent transfer Ethernet data in 1 to 4 E1 channels *0M/**0M Ethernet, full/half duplex self adapt, support VLAN. Ethernet support AUTO-MDIX( cross over and straight through self adapt) setting CRC alarm limitation to auto isolate lines with low transfer quality, single direction. When one direction error rate over limitation, disconnect only one direction, the other is not affected. Unbalance in two directions. Allow 4 E1 channels up to *0ms transfer delay. when the delay over the limitation, can stop transfer automatically. Having 2 loop back functions: E1 local loop, E1 external loop. Support Dynamic Ethernet MAC address(***6), having local address filter function. E1 interface compatible with ITU-T G.**3, G.**4, and G.**3. signaling slot not supported. E1 interface having internal clock resume circuit and HDB3 codec circuit. support E1 channel hot plug, and auto detect available E1 channels not pause the transmission. supporting 1 to 4 E1 channels customized configuration, auto detect the number of E1 channels and select the available E1 at reset. E1 Support *5ohm/unbalance impedance or **0ohm/balance for option support reset remote system from local system. having Ethernet monitor auto reset function Parameter and specifications E1 interface Standard: E1 interface compatible with G.**3 standard. Rate: 2.**8Mbit/są*0ppm Coding: HDB3 Impedance: *5ohm(unbalance) or **0ohm(balance) Connector: BNC(*5ohm) or RJ*5(**0ohm) Jitter Performance: According to G.**2 and G.**3 *0/**0Base-T Rate: *0M/**0M, full/half duplex self adapt. Protocol: support IEEE **2.3, IEEE **2.1 P, **2.1Q (VLAN) MAC address table: ***6 MAC addresses. Ethernet buffer: *4Mbits SDRAM Physical interface: RJ*5, support AUTO-MDIX(cross over and straight through self adapt) Dimension *9inch Type:**3 mm(L)×**8mm

Send a direct inquiry to this supplier

To:

Mr. robert < shanghai Baudcom Communication Device Co., ltd >

Je veux savoir: