FOB Price
Obtenir le dernier prix|
Minimum Order
Localité:
-
Prix de commande minimale:
-
Commande minimale:
-
Packaging Detail:
-
Delivery Time:
-
Supplying Ability:
-
Payment Type:
-
Hong Kong
Personne àcontacter Mr. Wong
ROOM A, 1/F, HAND WAI CRT,21-23 UN CHAU ST., SHAM SHUI PO, KLN, HONG KONG
The iMAX B5 Balance charger is designed to independently control the charging of each individual cell of a battery pack (parallel charging) up to 5 lipos cells, *4 cell NiMh or NiCad. You get a rapid charger that is computerized with a high performance microprocessor and specialized operating software. It can maintain your battery at its best condition and also control them safely. Please read this entire operating manual completely and attentively as it contains a wide of information you need to keep this manual in a safe place and be sure to pass it on to the new owner if you ever dispose of yours iMAX B5. * Operating voltage range: *0.***8.0 Volt * Circuit Power: MAX *0W * Charge current range: 0.**5.0A * Current drain for balacing Li-po: **0mA/cell * NiCd/NiMh: ***4 cell * Li-ion/Polymer: **5 series * Pb battery voltage: 6V or *2V * Weight: **0 g * Dimension: **0mm x *0mm x *3mm * LCD Display * Microprocessor controlled high-performance Rapid charger for NiCd/NiMH/Li-polymer/Li-ion/Pb batteries * Data store and load in B5 * Load polarity, short protection, and input polarity protection * Sturdy aluminum casing for maximum heat dissipation * Voltage balancer for Li-polymer battery inside B5 has an individual-cell-voltage balancer inside. So it does not need any balancer separately when charging Lipo battery for cell balancing. * Delta-peak sensitivity The automatic charge termination program works on the principle of the Delta-peak voltage detection. * Capacity limit The charging capacity always calculated by multiple of the charging current and time. If the charging capacity exceeds the limit the process will be terminated automatically when you set the maximum value. * Input power monitor To protect the car battery using as input power from being damaged the voltage of it always monitored. If it drops below the lower limit the process will be ended automatically.
