Seniod Solar Pump (lujin_1119(at)hotmail) MSN By Shanghai PVSupers New Energy Co., Ltd, China
Pas encore membre de TradeKey.com? Inscrivez-vous pour vous connecter avec 9 millions d'importateurs et exportateurs. Rejoignez-le maintenant c'est gratuit |
BOOK A CALL
Book Call On Your Favorite Time

By Signing Up. I agree to TradeKey.com Terms of Use, Privacy Policy, IPR and receive emails related to our services

Contact Us
Seniod Solar Pump (lujin_1119(at)hotmail) MSN

Seniod Solar Pump (lujin_1119(at)hotmail) MSN

900 USD /

|

Minimum Order

Localité:

shanghai

Prix de commande minimale:

Commande minimale:

1set

Packaging Detail:

-

Delivery Time:

7days

Supplying Ability:

130

Payment Type:

-

Contacter maintenant
Membre gratuit

Personne à contacter Mr. Joff

No.6601 Longdong Av road, shanghai, Shanghai

Contacter maintenant

Description

Contact MSN: lujin_***9(at) hotmail The Solar Pump can be also called solar water pump. Solar pump makes use of the solar energy to pump, clean, no pollution, simple and convenient. It solves the problem of agriculture irrigation, people&#**9;s and livestock&#**9;s water supply and frontier defense sentry water supply in the region where there is no water and no electricity. This product can automatically work at sunrise and stop at sunset without manpower. LIFT=*****0M, Water flow=5M********0L/h SYSTEM VOLLATGE=*4V**6V BATTERY OPERATION AND SOLAR OPERATION PLS contact MSN or email or send enquiry I. Configure of the electric power supply 1. Standard Output Rating (V):*4V *6V 2. The charging current of the solar PV array should be less than *0A. II. Special Feature of the Control System 1. The system is compact, weather proof and easy to install. 2. Completely controls charging, low-voltage, over voltage and pump motor protection during times of low water levels. 3. Load intermission protection. The system will protect itself and will not allow start-stop-start cycles within 3 minute intervals. III. The Steps of the installation 1. Open up the package, inspect for damaged components. 2. Ensure that the power switch on the control box is in the OFF position. ( the 0 position) 3. Connect the wires to the various components (solar panel, battery, transfer switch and water level sensor according to Figure 2 below. 4. Ensure that the transfer switch is switched to batter power. 5. Install the water level sensor and put it into the water. 6. After the wires are complete and verified, turn the switch on the control panel to ON (I Position) to start the water pump. If water pumps to the surface, then the installation is complete! IV. Caution 1. DO NOT Run the pump dry!!! It will void your warranty. The pump MUST be immersed in water at least 0.5m deep. 2. The pump must be immersed in the water for *5 to *0 minutes

Send a direct inquiry to this supplier

To:

Mr. Joff < Shanghai PVSupers New Energy Co., Ltd >

Je veux savoir: