JDSKM Inorganic Kation Silver Antibacterial Masterbatch for Plastics

La description

JDSKM Inorganic Kation Silver Antibacterial Masterbatch for Plastics

【Product Introduction】 
Kation Silver antibacterial material has the incomparable advantage of broad-spectrum, long-acting, non-toxic and non-residual effect. Therefore, Jinda Nano Tech developed this kation silver antibacterial masterbatch for plastics using kation silver antibacterial powder as active antibacterial ingredient and superior plastic raw material as carrier, and processing by advanced dispersion technology and processing method. It raises the dispersion effect of kation silver antibacterial agent in plastics, and can be directly added to general plastics and engineering plastics of PS, ABS, EVA, PE and PP.
The content of antibacterial powder is *0% which can also be customized by specific demand. It has superior modification effect on the resin base material, but not affecting the mechanical property of plastics.

【Product Characteristics】

1. Appearance: smooth surface, uniform size, no color difference and no obvious impurities.
2. Cleanness: Impure particle (other color mineral of Dia. 0.2mm to 1mm) is less than *0ea/**0g.
3. Broad-spectrum and long-acting antibacterial effect.
4. Uniform dispersion: After adding antibacterial masterbatch, the plastic products do not show any macroscopic solid grain.
5. Good heat stability, high temperature resistance and no discoloration.
6. Superior compatibility and dispersion, without changing the original spinning technique.
7. Antibacterial performance: The **-hour antibacterial rate of the plastic products adding specific proportion of antibacterial masterbatch reaches international, state and industry standards.
8. Toxicity to human body: No harm to body, no pollution to environment, no irritation to skin, no teratogenic degeneration after authorized test. It reaches the guiding standards of RoHS of European Union.

1. Before using, dry the masterbatch constantly for 2 to 4 hours in blast or vacuum oven at *0℃.
2. The production condition can be referred by that for certain plastics.
3. The suggested adding rate is as below, but can also be customized by specific request: