Prix FOB
Obtenir le dernier prix|
- Minimum Order
Pays:
China
N ° de modèle:
Chemicals, Coating & Paint
Prix FOB:
Localité:
-
Prix de commande minimale:
-
Commande minimale:
-
Packaging Detail:
-
Heure de livraison:
-
Capacité de Fournir:
-
Payment Type:
-
Groupe de produits :
-
Personne àcontacter Ms. ruby
Baiyun District, Guangzhou, China, Guangzhou, Guangdong
RAPICOAT 1K TINTERS Varied color cover full range with high color saturation |
Substrates | Dried and sanded existing finishes, primers | |
Substrates treatment | Remove paint dust and contaminations with degreaser before sanded | |
Temperature              Name         1K Basecoat color          Thinner | ||
Mixing ratio |
According to temp- erature to choose the Hardener and Thinner |
Volume Ratio          1part         **1.2part |
Remarks | At high temperature,it is recommended to use slow thinner or add proper retarder solvent to avoid defect. | |
Pot Life | *4 hours at *0℃. | |
Spray viscosity | ****2 Minutes at *0℃ | |
No. of coats | **3 coats, total ****5um | |
Flash-off time | At *5℃, ***0 minutes between coats. Allow ****0 minutes air-drying time before applying clear coat. | |
Each thickness | ****0Micron | |
Spray Pressure | Gravity Feed  1.**1.5mm   **4kg/cm2   Siphon Feed 1.**1.7mm  **4kg/cm2 | |
Drying Time | Temperature                     Dust Application time of next process | |
*0°C                         5 minutes                ****5mintutes | ||
Polishability | Use over P***0 sand paper if need polish | |
Shelf Life | 3 years in original sealed (can continue to use after passing inspection ) | |
Packing | 1LX*2tins/ctn,4LX4tins/ctn |
Note: 1: If the existing finish is not compatible, 2K primer surfacer should be used as a sealing layer before applying the basecoat otherwise there may be problems such as lifting, peeling, blistering, flooding, etc.' 2: At temperature over *0℃ or in high humidity, it is recommended to use Retarder Solvent to avoid defect. 3: Because of the high transparency of metallic basecoat, the primer surfacer should be in consistent color and flat without any sand scratches, seediness, or unevenness so as to prevent spot defect, poor metallic effect, etc.' 4: To avoid problems of spot or poor adhesion, the metallic paint film should not be thicker than *5um. 5: Better effect could be achieved if the extra silver powder could be removed with tack rag after the flash-off of every layer.
|
|