La description
1.Test each search site at least twice. Locate the transmitter at
least 50 feet from the first location for the second test. This
will eliminate the possibility that a null reading was caused by
the transmitter being placed directly on or within a few feet of
the target.
2.Remember that you should not have any electronic devices or metal
objects attached to your body, (especially cellular phones and
pagers).
3.The line is developed from the antenna in the ground not from the
case and/or transmitter.
4.Turn off transmitter when changing elements or when changing
position of transmitter for triangulation, and wait at least
fifteen (15) minutes before turning it back on. (This is to allow
the first line to fade before developing the intersecting
line.)
5.Do not add any metal or other test objects to the area being
tested while the transmitter is turned on.
6.Under certain conditions, the line formed between the transmitter
and the target may function as an antenna. Therefore you may hear
AM radio transmissions in your headset. You will only hear the
transmissions when you are on the line.
ADDITIONAL INSTRUCTIONS FOR THE EPX-7500 LONG RANGE KING
The following are step-by-step directions on the use of the antenna
and system.   Consult diagram to help you with
these directions.
Insert the antenna. While the antenna covers an area 360 around it,
the best useable area is that area radiating in front of and to 60°
from each side of the antenna. This area is enclosed within the
dashed lines of the diagram.
After you have established this sector; move to one of the edge of
one of the angles, approximately 15 from the antenna. You can be as
close as 10 to a maximum of 18. You dont need to go any further
from the antenna than this to determine whether there is a possible
target in the area covered between the two angles. Set the headset
volume to the lowest setting that you can still hear. Now begin
walking the arc between the two angles. You will hear a gradual
increase in the tone as you approach the center of the arc. This
tone will gradually decrease as you pass the arc and move toward
the other angle. If you cross a target line, as you walk the arc,
you will experience a sharp increase in tone that will immediately
decrease as you pass the line. If you experience this, the rods
should also cross.   Walk over that area again but
this time place
a flag where the sharp tone begins and another where it ends.
Continue to the far edge of the arc. Now walk back across the arc.
If you again experience the sharp increase in the tone place a flag
at the beginning and end as you did before.
The target line is in the center between the flags. Take a compass
reading of that line.
Now move the antenna to another location on the site and repeat the
procedure above.   The target is where the lines
cross.
Notice for Customers:
1. We warrant that the product will be free of manufacturing
defects for a period of 1 year from the date of purchase.
2. Following circumstances are above and beyond the free
maintenance service.
A. Damage caused by operation outside the instructions and notices
stated in the operation manual or instruction manual. Damage caused
by irresistible natural disasters
B. Damage caused by taking device apart without supplier
agreement.
| Pays: |
China |
| N ° de modèle: |
EPX-7500 Long Range King Metal Detector Diamond Detector
|
| Prix FOB: |
100 ~ 1000 / Set (Negotiable)
Obtenir le dernier prix
|
| Localité: |
- |
| Prix de commande minimale: |
100 per Set |
| Commande minimale: |
1 Set |
| Packaging Detail: |
Standard Packing |
| Heure de livraison: |
7 days after confirm the order |
| Capacité de Fournir: |
1000 Set per Month |
| Payment Type: |
- |
| Groupe de produits : |
gold detector
|
