1KW GRID TIE POWER INVERTER

La description

1. Description：  Directly connected to solar panel design（Without battery）  Angle with high precision auto-detect if it was held 0 Total  Step directly modulated high-frequency phase  Pure sine wave output  Solar luminosity power automatically adapt  Automatic power locking  Maximum Power Point Tracking(MPPT)  Automatically adapt to different load power factor  Constant current, constant-power design  Power grid automatically shut down when the output is faulty  Current limit protection  Schmitt trigger SPWM Generator(Output Pure sine wave)  Straight-line with the design  Multiple stack(Use of multiple machines in parallel)  Design of high frequency and high conversion rate 2. User Guide: Installation & Connection 1.1 Red Terminal: to connect positive pole of DC; Black Terminal: to connect negative pole of DC. AC Socket: to connect grid. Switch: Power Switch, after the proper connecting, turn on, Inverter start working. DC Input limits: Operating Voltage range: *2.5V to *8V Maximum Voltage: *8V Solar Panel: *0W minimum, only use PV panels with maximum power voltage at *7.5V. Can ONLY connect panels in parallel. DO NOT connect them in series! Wind Turbine: Rated output voltage *4VDC, Maximum voltage *8VDC AC Output: Grid Connection: **0V AC version: **0V***0V, *0Hz **0V AC version: *0V***0V, *0Hz Island Protection: Automatically disconnect when the grid is tripped Maximum quantity of Pure Sine-wave Inverters allowed on a main circuit: No limited LED Indicators: Red LED on: Input DC voltage is too high or low (less than *2.5V or more than *8V) Red LED on: Over Heat protection once over *0℃, automatic restart after cooling down for about ***0 minutes. Red LED on: Grid blackout fault Green LED Flashing: Output power in the state of regulation. Green LED on continuously: Inverter works normally, constantly max. output power. Caution: Please do install the inverter in a ventilated area to avoid over-heating Clear out any flammable object around the installation Recommend a maximum output DC cable size of 4AWG or cables that can handle more than *0A. Optimal length would be 8m or lower, Longer cables will experience higher voltage drop. Install in a low humidity and well-ventilated area. Remove All flammable objects. Connect the inverter to a wall socket with the supplied AC Power Cord Connect the Solar Panel, Battery or Wind Turbine's DC Supply cables to the DC Terminal of the inverter. Wind Turbine installations will require respective charge Controllers and dump loads